CPE7000 Default User Name

CPE7000 Default User Name

 

After version .82 of the firmware, the new default user pass for the CPE7000 is operator/Telrad4G if you reset it to factory defaults.

 

    • Related Articles

    • Having trouble accessing a default configuration page on wireless hardware?

      One of the most frequent issues that I receive is the inability to access the default login page on new equipment.  Sometimes the page comes up but the username and password do not work or even not at all. Web Page Inaccessible/"Easy" Configuration ...

    • MikroTik RouterOS Default Wireless WPA2 Key

        Here is one that caught me by surprise and several of our customers as well. MikroTik's default configuration for devices with wireless has changed. There is now WPA/WPA2 security on the wireless connection. You will need to enter the serial number ...

    • Grandstream P-Codes

      P-Code Retrieval One of the most common ways to generate a P-Code Template is to configure the phone using the webUI and exporting the phones configuration, which can be found under Maintance > Upgrade and provisioning. If you are unsure of a P-Code ...

    • Build a WISP

        Article courtesy of wiki.ubnt.com Contents 1 Introduction 2 Legal and commercial requirements 3 BaseStation 4 Minimum requirements: 5 A CALEA compliant system (in the U.S.) 6 STEP BY STEP 7 AP  Wireless Page 8 Clients 9 CPE- Wireless Page 10 CPE- ...

    • Using Baicells L2 Mode

      To change LGW mode, navigate to the Network -> LGW page. In LGW L2 mode, the eNB will create a virtual interface for every UE that attaches. Each virtual interface will then do a DHCP request and create a 1:1 mapping between the UE IP (from Cloud ...