Startup WISP Design

Startup WISP Design

This is a basic concept of how you can deploy fixed wireless with TDMA or LTE equipment.

    • Related Articles

    • Build a WISP

        Article courtesy of wiki.ubnt.com Contents 1 Introduction 2 Legal and commercial requirements 3 BaseStation 4 Minimum requirements: 5 A CALEA compliant system (in the U.S.) 6 STEP BY STEP 7 AP  Wireless Page 8 Clients 9 CPE- Wireless Page 10 CPE- ...
    • Solar Permit Design Package

      This is the package we submitted for the Ubiquiti Sunmax Solar installation at our office.  An engineering firm quoted $5000 for this package, we did it ourselves!
    • How to Install Baicells HaloB for WISP LTE Networks

      What is HaloB HaloB is an optional solution for Baicells LTE networks to increase the reliability and stability of their LTE system when network connectivity challenges occur or during times of maintenance to the Cloud based EPC.  Since the EPC is ...
    • Netonix WISP-Switch & Mikrotik Router on a Stick Howto

      In this example we will build a router on a stick. We want to manage the switch from port 8 using inter vlan routing on the router. Here is the physical setup: 1. To configure the switch, set an IP address of 192.168.1.1/24 on your laptop and log ...
    • Frequency Options available to WISPs

      Frequency Options available to WISPs   2.4 GHz Unlicensed PTMP Frequency is saturated and unusable in most areas for WISps   2.5 GHz Licensed PTMP Best choice for penetration, non line of sight (NLOS) Best performance due to no interference Hardest ...